Start-Stop aktiviert, funktioniert aber nicht. 24.05.2020, 21:00. Hallo zusammen, unser Dicker ist ja noch ziemlich frisch, so weit scheint alles gut zu funktionieren - bis auf das Start-Stop-System. Da kam vor einiger Zeit Mal eine Fehlermeldung, allerdings unspezifisch. Ich habe das System dann manuell deaktiviert und wieder aktiviert.
Just had my 2010 Berlingo HDI 75 back from the garage as the heater fan/blower stopped working. I replaced the "resistor" above the accelerator hoping that would cure the issue but no luck. Garage reckon the heater "blower motor" is at fault due to water ingress causing corrision, but they have not been able to find one other than at CitroenHi, im having trouble with a 2007 Belingo Multispace 1.6 hdi concerning brake bleeding. I have replace both wheel cylinders and bled system. The pedal went away so i replaced the master cylinder. There is now a pedal but it has too much travel for my liking. If i let off and pump again then the pedal is good. I have carried out normal bleeding
My Citroen Berlingo 1.6 CDi Emission control system warning light. I think I have a very tiny fuel leak. Van struggles to start on first start of the day, if I hand pump to prime system I can get it started and it's fine for the day. Today the emission control system warning light came on and has stayed onis this linked and what's the likely
Not difficult to tighten up on the Berlingo, just requires removing the air box. A good way to check the injectors is to get a piece of tube & hold it next to your ear. Then just hover it around the engine next to,the noise, it works like a stethoscope & makes it very easy to pinpoint the source of the noise or blow.So the van will still bump I presume, but we have now an intermittent starting problem, the mechanic and I started it off the key 3-4 times, then it didn't start a couple of times then it started, I have used it most of the day with it once failing to start on 1st and 2nd try but then started, then early this evening it didn't start and refused
YAzeRm.